Welcome to Farmers Feed and Seed Service page. Please click on any of the following services below to find out more information and to request more information. Our hours are Mon-Fri 7:30-5:00 and Sat. 7:30-1:00

Zero-Turn Service
Farmers Feed and Seed and Diamondback Outfitters
311 N Main St
Kernersville, NC

Service Description

Check unit over. Change the Engine Oil and Oil Filter* if needed. Replace the Air Filter, Pre Filter**, Fuel Filter, and Spark Plug(s)*** if needed. Check the battery and charging system output. Clean the battery terminals if needed and treat with anti-corrosion spray. Adjust the air pressure in all the tires. Sharpen and Balance the blades. Clean out the deck if needed(top and bottom). Check the deck level, belts, bearings, and pulleys. Lubricate any grease fittings****. Check and top off Hydraulic fluid if needed*****. Perform any minor adjustments needed. Test run unit.

Farmers Feed & Seed only repairs Toro and Hustler zero-turns during the busy season due to the volume of repair work we encounter. During the off season we do service other brands as long as we can get parts for them. Just call if you have any questions.

Our cost is $85 labor minimum + parts and tax on 1 and 2 blade units, $102 labor minimum + parts and tax on 3 blade units.

All additional repairs/diagnostic time needed will result in additional labor, parts, and tax.

* Not all engines are equipped with oil filters.

** Not all engines are equipped with pre filters.

*** Single cylinder engines require 1 spark plug, Twin cylinder engines require 2 spark plugs.

**** Not all zero-turns have grease fittings

***** Not all zero-turns have Hydraulic fluid that can be checked(Sealed Hydraulic Systems).